The command employed in AutoCAD® to create a mesh from a line or curve that is swept along a straight path (as shown in the figure below) is \underline{\hspace{1cm}}.
\begin{center}
\includegraphics[width=0.5\textwidth]{04.jpeg}
\end{center}
Show Hint
- TABSURF
- REVSURF
- RULESURF
- EDGESURF
Questions Asked in GATE AR exam
A four-arm uncontrolled un-signaled urban intersection of both-way traffic is illustrated in the figure. Vehicles approaching the intersection from the directions A, B, C, and D can move to either left, right, or continue in straight direction. No U-turn is allowed. In the given situation, the maximum number of vehicular crossing conflict points for this intersection is _________ (answer in integer)
- GATE AR - 2025
- Traffic survey methods, Traffic flow Analysis
An individual chooses a transport mode for a particular trip based on three attributes i.e., cost of journey (X), In-vehicle travel time to reach destination (Y), and Out-of-vehicle time taken to access mode at respective stops (Z). The values for these attributes for three modes Rail, Bus and Para-transit are given in the table. If the general utility (U) equation is \( U = - 0.5 \times X - 0.3 \times Y - 0.4 \times Z \), using the Logit model, the estimated probability of choosing Bus is _________ (rounded off to two decimal places).
- GATE AR - 2025
- Transportation