Match the Education facilities with their respective population semed per unit
Top Questions on Architectural Graphics
- With reference to the Figure below, which of the following labelling is/are correct?
- GATE AR - 2024
- Architecture, Planning and Design
- Architectural Graphics
- The surface development of a three dimensional object is shown in the figure. The dotted lines indicate the folds. The dimensions given in the figure are in cm. The volume of the three-dimensional object (in cu.cm) is \underline{\hspace{1cm}} [rounded off to one decimal place]. \begin{center} \includegraphics[width=0.5\textwidth]{07.jpeg} \end{center}
- GATE AR - 2023
- Architecture, Planning and Design
- Architectural Graphics
- Want to practice more? Try solving extra ecology questions todayView All Questions
Questions Asked in GATE AR exam
A four-arm uncontrolled un-signaled urban intersection of both-way traffic is illustrated in the figure. Vehicles approaching the intersection from the directions A, B, C, and D can move to either left, right, or continue in straight direction. No U-turn is allowed. In the given situation, the maximum number of vehicular crossing conflict points for this intersection is _________ (answer in integer)
- GATE AR - 2025
- Traffic survey methods, Traffic flow Analysis
An individual chooses a transport mode for a particular trip based on three attributes i.e., cost of journey (X), In-vehicle travel time to reach destination (Y), and Out-of-vehicle time taken to access mode at respective stops (Z). The values for these attributes for three modes Rail, Bus and Para-transit are given in the table. If the general utility (U) equation is \( U = - 0.5 \times X - 0.3 \times Y - 0.4 \times Z \), using the Logit model, the estimated probability of choosing Bus is _________ (rounded off to two decimal places).
- GATE AR - 2025
- Transportation