A simply supported beam is under a uniformly distributed load (UDL) along the full span. The mid-span deflection is measured as 24 mm. If the length and depth of the beam is doubled while keeping other parameters unchanged, the mid-span deflection is _______ mm.
Show Hint
Top Questions on Solar Energy
- Which are the two wavelength bands of light spectrum used to calculate the Normalised Difference Vegetation Index (NDVI) in remote sensing?
- Affordable Housing in Partnership (AHP) is one of the verticals of Pradhan Mantri Awas Yojana (PMAY) of Government of India. In AHP, the partnership was envisaged between __________
- There are 16 similar machines located radially and equally distanced from a fixed sound receiver. While operating, each machine records 60 dB sound level at the receiver. Assuming 70 dB to be the highest sound level allowed as per the industrial sound pollution norms, the total number of machines allowed to operate simultaneously without violating the norms is _________. (rounded off to the nearest integer)
- A source of light is located at point C. Point A is 1.75 m vertically below point C. Point B is situated horizontally 1.0 m right of point A. If the illumination level at point A due to the light source at point C is 300 Lux, then the illumination level at point B is _________ Lux. (rounded off to the nearest integer)
- Want to practice more? Try solving extra ecology questions todayView All Questions
Questions Asked in GATE AR exam
A four-arm uncontrolled un-signaled urban intersection of both-way traffic is illustrated in the figure. Vehicles approaching the intersection from the directions A, B, C, and D can move to either left, right, or continue in straight direction. No U-turn is allowed. In the given situation, the maximum number of vehicular crossing conflict points for this intersection is _________ (answer in integer)
- GATE AR - 2025
- Traffic survey methods, Traffic flow Analysis
An individual chooses a transport mode for a particular trip based on three attributes i.e., cost of journey (X), In-vehicle travel time to reach destination (Y), and Out-of-vehicle time taken to access mode at respective stops (Z). The values for these attributes for three modes Rail, Bus and Para-transit are given in the table. If the general utility (U) equation is \( U = - 0.5 \times X - 0.3 \times Y - 0.4 \times Z \), using the Logit model, the estimated probability of choosing Bus is _________ (rounded off to two decimal places).
- GATE AR - 2025
- Transportation